How much does it cost to fix electronic throttle control?

The average for Electronic Throttle Control is $616

Repair Type	Zip	Cost
Electronic Throttle Control	37093	$559
Electronic Throttle Control	2702	$834
Electronic Throttle Control	96724	$716
Electronic Throttle Control	91642	$1050

.

People also ask, how much does it cost to replace an electronic throttle control?

The average cost for a throttle body replacement is between $577 and $691. Labor costs are estimated between $92 and $117 while parts are priced between $485 and $574. Estimate does not include taxes and fees. When would you like to drop off your car?

how much does it cost to fix etc light? Replacement Cost In most cases, you don't need to change the ETC but if you have to you can expect to spend in excess of $200 – $300 and that too depending on the make and model of your car.

Keeping this in consideration, what happens when the electronic throttle control goes bad?

When a TPS goes bad, then the car's throttle body won't function properly. It could either stay shut or it won't close properly which is a severe issue. If it stays shut then your engine is not going receive air and it won't start.

How do I reset my electronic throttle control manually?

Turn the ignition switch on and wait 3 seconds. Immediately after the 3 seconds, the accelerator pedal must be pressed and released 5 times within 5 seconds. Wait 7 seconds and fully press the accelerator pedal and hold for approximately 20 seconds until the check engine light stops blinking and stays on.

Related Question Answers

Can you drive with a bad throttle body?

If you have a bad throttle position sensor, your car will not perform well or safely. Driving with a bad throttle position sensor may also cause problems in other related systems in your car, which will mean additional repair bills.

Can you drive with electronic throttle control light on?

Can you drive with the ETC light on? In some specific situations you can, such as when your car runs normally but is getting bad fuel economy. But if you can no longer control your car's acceleration, you must have it towed to a repair shop immediately.

What causes the throttle body to fail?

Vacuum leaks or an incorrectly adjusted throttle stop Vacuum leaks can disrupt the air/fuel flow due to an imbalance of air flow which can cause throttle body pressure problems. This is a component that acts as a gate-keeper and establishes a minimum or maximum position for a throttle body plate to be opened or closed.

Do you have to program a throttle position sensor?

Code errors can cause your throttle position sensor to work erratically or incorrectly. Otherwise, you'll need professional software to reprogram your sensor. This job is best done by a professional mechanic. If your sensor just needs repairs, it could be the result of faulty or loose wiring.

How do you program a throttle body?

step 1: Accelerator Pedal Release Position Learning (0:15)

1. Do not depress the accelerator pedal.
2. Turn the key to the ON position for atleast 2 seconds.
3. Turn the key to the OFF position for 10 seconds.
4. Turn the key to the ON position for 2 seconds.
5. Turn the key to the OFF position for 10 seconds.

Does the throttle body need to be replaced?

The throttle body plays a large role in controlling the fuel and air mixture in your engine. The proper mixture needs to be achieved in order for your engine to run smoothly and properly. Once this part fails, it needs replacing rather than repairing.

What is the lightning bolt on my dash?

The lightning bolt on the dash means that there is a problem with the electronic throttle control system in your vehicle. Slowly depress the accelerator pedal all the way to the floor. Slowly release the accelerator pedal until it is all the way back up at the rest position.

How do you diagnose a bad throttle position sensor?

Here are some common symptoms of a bad or failing throttle position sensor to watch for:

1. Car won't accelerate, lacks power when accelerating, or accelerates itself.
2. Engine won't idle smoothly, idles too slowly, or stalls.
3. Car accelerates, but won't exceed a relatively low speed, or shift up.

How do you fix a throttle body problem?

How to Clean or Replace a Faulty Throttle Body

1. Tools and Materials.
2. Remove Hose from Throttle Body. With the engine off, locate the air filter case.
3. Spray Cleaner into Throttle Body.
4. Reconnect the Hose.
5. Test Drive.
6. Tools.
7. Detach the Air Cleaner.
8. Deactivate the Idle Air Control.

What happens if you disconnect throttle position sensor?

If the TPS is not adjusted correctly as evidenced by a 500rpm idle, and hesitation with initial acceleration, unplugging the TPS connector should then cause a correct idle, and a normal acceleration. Correcting the TPS then produced a correct idle, and no code.

How often should you get throttle body service?

It may need its oil changed once or twice a year, and there is a cabin air filter to change a few times on your way to 100,000 miles, but there's not much more to do until the big single service involving a timing belt change and spark plugs at around that point.

Can a throttle position sensor stop a car from starting?

The only way a TPS will cause a no-start is if the TPS is busted/stuck, and the TPS is telling the computer that you've floored the gas. The computer won't pulse the injectors, because when you floor the gas (WideOpenThrottle) and crank the engine, the computer goes into "clear flood mode".

Can you clean a throttle position sensor?

Cleaning the throttle body itself can be done using carburetor fluid and a clean cloth for the removal of light sludge. During this process, the throttle position sensor should not be cleaned due to the possibility of contamination or wire damage.

Can a dirty throttle body cause a check engine light?

The check engine light can indicate many issues within a car including a faulty throttle body. Any problem detected with it will turn on the check engine light. As a part of your regular service intervals, include the air induction service and fuel injection flush to clean out any carbon deposits and dirt.

Why does electronic throttle control light come on?

A flashing electronic throttle control light can be connected to an abrupt change in the fuel economy. You may need to fill up the tank more than usual. It happens due to a damaged throttle controller. The system controls the air-fuel mixture that goes into the engine.

What does it mean to service electronic throttle control?

Electronic throttle control (ETC) is an automobile technology which electronically "connects" the accelerator pedal to the throttle, replacing a mechanical linkage. The electric motor is then used to open the throttle valve to the desired angle via a closed-loop control algorithm within the ECM.

Is electronic throttle control covered under warranty?

The electronic throttle body most likely is not part of the powertrain warranty, but may be covered under the emissions warranty. Have a dealership run the part number, vin # and mileage under the tab "parts coverage" web page in the OASIS website.

What does red lightning bolt on Dodge mean?

This lightning bolt refers to an Electronic Throttle Control problem, or an ETC error. You need to get this car to a mechanic SOON.

Where is the throttle position sensor located?

Throttle Position Sensor (TPS) Repair Guide Fig. The Throttle Position (TP) Sensor is located on the rear of the intake manifold. The Throttle Position (TP) Sensor is located on the bulkhead, above the accelerator pedal. The Throttle Position (TP) Sensor is located on the bulkhead, above the accelerator pedal.